Burst pressure tests
burst pressure test (HydrauliC & GAs)
You want to check at which position and at which operating pressure does the material failure of your component occur? We can pressurize your development component up to a pressure of 4000 bar (hydraulic) and, if desired, with gas up to a pressure of 1550 bar. We will then carry out the analysis for you.
Extract of possible components and systems :
We will test according to your specifications or according to the standards applicable to you r technical regulations. (e.g. ANSI HGV 2-2014, ECE R67, ECE R110,…)
Fire tests
fire test
You would like to check whether the safety devices of your components respond in the event of a fire?
Or have flame protection tests to be carried out according to the relevant EU standards?
Examples:
We are your partner for fire tests, especially for tests with explosive gases or liquids.
HV-Battery
The range of services starts with tests which, although associated with an increased safety risk, are usually not destructive to the component. For example, with IP degree of protection according to ISO 20653 for "sharp" HV batteries or the effects of thermal cycles including humidity or thermal shocks. Also drop tests are possible.
Focus of the area are test benches and testing stations for HV batteries. This creates a variety of possible tests. Electrical overstress such as over- / deep-discharging, overcurrent, short-circuits can be tested. The test spectrum also covers mechanical influences such as the penetration of nails or punches. In addition, safety technology for HV batteries such as storage or transport containers can be tested. A variety of other applications is thinkable and feasible.
An extract of possible test followint international or national standartization:
UN T 38.3 / ECE R 100 / ECE R 136 / SAE J 2464 / IEC 62133 / FreedomCAR / DIN EN 62620 / DIN EN 62281 / DIN EN 62660-1&2 / GB/T 31467.3-2015
DIVISIONS
COMPANY
SERVICE